| How to fit your decal and get the best results |
| All screen decals must be placed on the inside unless stated otherwise. |
| The Porsche 928 rear letters need to be fitted one letter at a time. |
| Fit the decal in a warm enviroment. |
| Clean the surface where the decal is to be fitted
thoroughly with Windex or alcohol (ensure that the cleaner doesnt damage paintwork. it is important that there is no wax or grease
on the surface) |
| Place the decal on the surface and hold in place with a piece of masking tape on one edge so that
you can still lift the decal from the surface |
| Carefully peel off the backing that is next to the surface that the decal is to be applied to |
| Spray a mixture of soap and water or Windex on the area the decal is to be applied
this will help stop air bubbles and allow you to position the decal accurately |
| Lay the decal onto the surface, slide it into the position you require it
and with a credit card, starting at the middle work out all the liquid |
| Leave to dry for 15 to 30 minutes |
| Carefully remove the masking tape and the decal backing ensuring
the decal does not come off with the backing. Do this slowly. |
| Do not wash the arear vigourosly for a couple of weeks |
| To remove a decal |
| Use a heat gun to warm the decal and peel it off gently |
| To remove any additional glue use rubbing alcohol or similar compound
(ensure that this does not mark the paintwork) |
